Cisco Firepower 4100 Series Manuel du produit - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel du produit pour {nom_de_la_catégorie} Cisco Firepower 4100 Series. Cisco Firepower 4100 Series 17 pages. Rack-mount and ground the chassis
Également pour Cisco Firepower 4100 Series : Manuel (8 pages), Manuel de maintenance et de mise à jour (20 pages), Manuel (36 pages), Manuel (8 pages), Manuel (42 pages), Manuel (38 pages)
Imprimer la page
Installation and Configuration
Connecting and Using the CLI Console
For initial system configuration, use the CLI console. As shown in
to the controller front-panel console port.
Figure 4
Follow these steps to connect the CLI console to the controller:
Use a null-modem serial cable to connect the CLI console to the controller console port.
Step 1
Note
Be sure that the VT-100 terminal emulator (HyperTerminal, ProComm, minicom, tip, or other) is
Step 2
configured for the following parameters:
•
•
•
•
•
Performing Power On Self Test
When you plug the controller into an AC power source, the bootup script initializes the system, verifies
the hardware configuration, loads its microcode into memory, verifies its Operating System software
load, and initializes itself with its stored configurations.
78-17155-01
CLI Console Connection to a controller
The controller end of the cable is female DB-9. The other end should be any kind of connector
that plugs into your VT-100 terminal emulator (usually a laptop or palmtop computer).
9600 baud
8 data bits
no flow control
1 stop bit
no parity
Cisco 4100 Series Wireless LAN Controllers - Installation and Configuration Guide
Connecting and Using the CLI Console
Figure
4, the CLI console connects
9