Cisco Firepower 4100 Series Instrukcja obsługi produktu - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi produktu dla Sprzęt sieciowy Cisco Firepower 4100 Series. Cisco Firepower 4100 Series 17 stron. Rack-mount and ground the chassis
Również dla Cisco Firepower 4100 Series: Podręcznik (8 strony), Podręcznik konserwacji i aktualizacji (20 strony), Podręcznik (36 strony), Podręcznik (8 strony), Podręcznik (42 strony), Podręcznik (38 strony)

Drukuj stronę
Cisco Firepower 4100 Series Instrukcja obsługi produktu
Installation and Configuration

Connecting and Using the CLI Console

For initial system configuration, use the CLI console. As shown in
to the controller front-panel console port.
Figure 4
Follow these steps to connect the CLI console to the controller:
Use a null-modem serial cable to connect the CLI console to the controller console port.
Step 1
Note
Be sure that the VT-100 terminal emulator (HyperTerminal, ProComm, minicom, tip, or other) is
Step 2
configured for the following parameters:
•
•
•
•
•

Performing Power On Self Test

When you plug the controller into an AC power source, the bootup script initializes the system, verifies
the hardware configuration, loads its microcode into memory, verifies its Operating System software
load, and initializes itself with its stored configurations.
78-17155-01
CLI Console Connection to a controller
The controller end of the cable is female DB-9. The other end should be any kind of connector
that plugs into your VT-100 terminal emulator (usually a laptop or palmtop computer).
9600 baud
8 data bits
no flow control
1 stop bit
no parity
Cisco 4100 Series Wireless LAN Controllers - Installation and Configuration Guide
Connecting and Using the CLI Console
Figure
4, the CLI console connects
9