- ページ 9

ネットワーク・ハードウェア Cisco Firepower 4100 SeriesのPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Firepower 4100 Series 17 ページ。 Rack-mount and ground the chassis
Cisco Firepower 4100 Series にも：マニュアル (8 ページ), メンテナンスとアップグレードマニュアル (20 ページ), マニュアル (36 ページ), マニュアル (8 ページ), マニュアル (42 ページ), マニュアル (38 ページ)

Installation and Configuration

Connecting and Using the CLI Console

For initial system configuration, use the CLI console. As shown in

to the controller front-panel console port.

Figure 4

Follow these steps to connect the CLI console to the controller:

Use a null-modem serial cable to connect the CLI console to the controller console port.

Step 1

Note

Be sure that the VT-100 terminal emulator (HyperTerminal, ProComm, minicom, tip, or other) is

Step 2

configured for the following parameters:

•

When you plug the controller into an AC power source, the bootup script initializes the system, verifies

the hardware configuration, loads its microcode into memory, verifies its Operating System software

load, and initializes itself with its stored configurations.

78-17155-01

CLI Console Connection to a controller

The controller end of the cable is female DB-9. The other end should be any kind of connector

that plugs into your VT-100 terminal emulator (usually a laptop or palmtop computer).

9600 baud

8 data bits

no flow control

1 stop bit

no parity

Cisco 4100 Series Wireless LAN Controllers - Installation and Configuration Guide

Connecting and Using the CLI Console

Figure

4, the CLI console connects