B2 Audio RAGE 600.4 Manuel - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} B2 Audio RAGE 600.4. B2 Audio RAGE 600.4 16 pages.

Power & speaker terminal

rage600.4

gnd

onnects to the vehicle's chassis. Keep as short as

possible (< 20" / 50 cm). Use minimum 4AWG cable

optimal operation.

rem

Connects to +12V switched remote from the headunit.

It can also use switched +12V source for external units.

If several units are installed in the car, it can be wise with

a relay to ensure su cient voltage is present.

+12 (power connection)

Connects to the positivie terminal of the battery.

For speci ed performance 4AWG cable is required.

Fuses shall be placed within 8" / 20 cm of the battery.

volt led indicator

Flashing led indicates power supply voltage is below

recommended to achieve the ampli ers rated performance.

Continious negligence of the indicator can cause damage to

your sound system & reduced performance.

pwr led

Shows the amplifer is connected to both +12V power and

is grounded at the same time.

SPEAKER

BRIDGED

pro led

Ampli er has gone into protect mode.

The malfunction could be caused by speaker short,

thermal protect, faulty connection or general errors.

clip led (active on ch 3/4)

Flashing led indicates signal is clipped on ch 3 and ch 4.

Set gains in accordance, so clip indicator is only ashing

at absolute peak levels.

speaker output terminals

Connects to the speakers pos & neg terminals.

Use a 12AWG cable for optimal performance.

The RAGE 600.4 is stable to 4 ohm bridge or 2 ohm stereo.

Bridge mode is enabled by connecting the speaker cables

to the terminals indicated on the illustration above.