TomTom LINK 510 Manuel d'installation - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} TomTom LINK 510. TomTom LINK 510 35 pages. Vehicle tracking device
Également pour TomTom LINK 510 : Manuel de l'utilisateur (37 pages), Manuel d'installation (16 pages)

Imprimer la page

Connecting to power

Connect the LINK 510 to the vehicle power supply with the standard vehicle voltage (12 V/

Con-

nect-

ing to

power

24 V). Do not connect to a voltage converter. The three wires GND, IGN and PWR+ (supply

voltage) must be connected.

Important: Follow the order of connecting the wires as described below. First connect the

wires then insert the plug into the LINK 510.

If you have inserted the plug into the LINK 510 first, you must connect the GND wire before

you connect the PWR+ wire and the IGN wire as described below.

1. Connect the GND wire (brown) to ground (clamp 31).

2. Connect the PWR+ wire (red) to the carry current (clamp 30).

The connection must be fused with max. 10A. If not, fuse the the PWR+ wire with one

2A fast blow fuse.

3. Connect the IGN wire (black) to ignition (clamp 15).

The connection must be fused with max. 10A. If not, fuse the the IGN wire with one 2A

fast blow fuse.

4. Insert the 3-pin plug into the power cable connector.

If you need to disconnect the wires while the 3-pin plug is plugged in the LINK 510 make

sure you disconnect the GND wire last.