TomTom LINK 510 Manuel d'installation - Page 32

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} TomTom LINK 510. TomTom LINK 510 35 pages. Vehicle tracking device
Également pour TomTom LINK 510 : Manuel de l'utilisateur (37 pages), Manuel d'installation (16 pages)

Imprimer la page

Wiring the digital output

The digital output OUT of the LINK 510 is an open drain output linking to ground. The

connected load must be connected between vehicle voltage and OUT. Loads requiring

more than 0.35 A must be controlled with relays. If the load requires more than the

maximum output voltage use a 12 V/24 V relay, depending on the operating voltage.

Caution

Do not switch safety relevant vehicle functions.

Accessing FMS data

With the TomTom LINK 510 and the IO cable from TomTom Business Solutions you

access the FMS interface of your vehicle. Connect the CAN H and the CAN L wires of the

IO cable to the CAN H and the CAN L pins of the FMS connector in your vehicle.

Note: Make sure you have linked the GND wire of the IO cable from TomTom Business

Solutions to ground.