TomTom LINK 510 Посібник з монтажу - Сторінка 32

Переглянути онлайн або завантажити pdf Посібник з монтажу для GPS TomTom LINK 510. TomTom LINK 510 35 сторінок. Vehicle tracking device
Також для TomTom LINK 510: Посібник користувача (37 сторінок), Посібник з монтажу (16 сторінок)

Друкувати сторінку

Wiring the digital output

The digital output OUT of the LINK 510 is an open drain output linking to ground. The

connected load must be connected between vehicle voltage and OUT. Loads requiring

more than 0.35 A must be controlled with relays. If the load requires more than the

maximum output voltage use a 12 V/24 V relay, depending on the operating voltage.

Caution

Do not switch safety relevant vehicle functions.

Accessing FMS data

With the TomTom LINK 510 and the IO cable from TomTom Business Solutions you

access the FMS interface of your vehicle. Connect the CAN H and the CAN L wires of the

IO cable to the CAN H and the CAN L pins of the FMS connector in your vehicle.

Note: Make sure you have linked the GND wire of the IO cable from TomTom Business

Solutions to ground.