TomTom LINK 510 설치 매뉴얼 - 페이지 32

{카테고리_이름} TomTom LINK 510에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. TomTom LINK 510 35 페이지. Vehicle tracking device
TomTom LINK 510에 대해서도 마찬가지입니다: 사용자 설명서 (37 페이지), 설치 매뉴얼 (16 페이지)

페이지 인쇄
TomTom LINK 510 설치 매뉴얼

Wiring the digital output

The digital output OUT of the LINK 510 is an open drain output linking to ground. The
connected load must be connected between vehicle voltage and OUT. Loads requiring
more than 0.35 A must be controlled with relays. If the load requires more than the
maximum output voltage use a 12 V/24 V relay, depending on the operating voltage.
Caution
Do not switch safety relevant vehicle functions.

Accessing FMS data

With the TomTom LINK 510 and the IO cable from TomTom Business Solutions you
access the FMS interface of your vehicle. Connect the CAN H and the CAN L wires of the
IO cable to the CAN H and the CAN L pins of the FMS connector in your vehicle.
Note: Make sure you have linked the GND wire of the IO cable from TomTom Business
Solutions to ground.
32