Epson 7850p - PowerLite XGA LCD Projector Manuel d'information sur les produits - Page 19

Imprimer la page

Epson 7850p - PowerLite XGA LCD Projector Manuel d'information sur les produits

EPSON PowerLite 7850p Projector

If you're using a network management utility running SNMP,

you can configure your network to send trap alerts even without a

plug-n. See the User's Guide for more information.

Make sure you have installed the EMP Monitor software

(included on the projector's CD-ROM) on the computer you

want to use to monitor your projectors. (See the User's Guide

for instructions.)

Note: Your computer must be running Microsoft Windows XP,

2000, Me or 98.

Setting Up the Projector on a Wired Network

This section explains how to configure projectors on a wired

network. You can also configure projectors for wireless

communication. See "Configuring the Connection" on

page 12 for details.

1. Insert the PCMCIA LAN card into the card slot on the

back of the projector. Then connect the projector to your

network using a commercially available 100baseTX or

10baseT network cable.

2. Turn on the projector.

3. Press the

button on the remote control and select

from the

Network

Advanced2

Video

Brightness Control

Audio

Projector ID

Effect

Network

Setting

COM Port

User's Logo

Auto setup

Advanced1

BNC Sync Termination

Advanced2

Reset

About

Reset All

[

]: Select

[

]: Enter

4. If your network assigns addresses automatically, turn on

DHCP

If your network does not assign addresses automatically,

turn off

and enter the projector's

DHCP

Subnet Mask

Gateway Address

needed.

❏ To enter numbers using the remote control, press the

button until it lights, then use the numeric

Num

keypad.

Num button

EPSON PowerLite 7850p Projector

menu.

High

Low

: 1

Set

Select

Set

RS-232C

USB

Network

ON OFF

OFF

ON OFF

OFF

Execute

[Menu]: Exit

IP Address

, and

MAC Address

Zero

❏ To change the network addresses from the projector's

control panel, press the right and left arrow buttons to

select the part of the address you want to enter, then

use the up and down arrow buttons to increase or

decrease the numeric value.

Select the part of the

address to change

5. When you finish changing an address in the network menu,

press the

Enter

Auto/Enter

value.

6. When you're done making all necessary changes, press

to exit the menu system.

Opening and Closing EMP Monitor

To start EMP Monitor, click

Programs > EPSON Projector > EMP Monitor

If you've added the program to the Startup programs folder, it

may already be open. If so, click the icon in the system tray on

the lower-right corner of your screen to display the EMP

Monitor window:

To close EMP Monitor, right-click the program icon shown

above, then select

, as

6/03

button (on the remote control) or the

button (on the projector). This stores the

Start > Programs or All

Click here to start EMP Monitor

Exit

Increase or

decrease

the value

ESC