Pioneer VSA-1000 Manuel d'utilisation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Pioneer VSA-1000. Pioneer VSA-1000 35 pages. Av digital surround amplifier
Également pour Pioneer VSA-1000 : Manuel d'utilisation (35 pages)

Imprimer la page

SURROUND EFFECT

SURROUND

SPEAKER INSTALLATION

EXAMPLE

To get the best effect out of the surround system, place the speakers

as shown below.

A typical surround speaker arrangement

CENTER SPEAKER

Listening area

When

DOLBY

PRO

LOGIC

SURROUND

is used

without

a center

speaker, set the CENTER

MODE switch to the PHANTOM

position.

With DOLBY PRO LOGIC SURROUND, monaural source sound will be

heard only from the center channel at settings other than the PHANTOM

position.

NOTE:

;

* To avoid interference

with the picture on a nearby

TV set, use

magnetically shielded speaker systems. This is particularly important

for the center speaker since it is usually located closest to the TV.

the TV set.

* Position the center speaker above, below, or behind the TV set. Sound

may not appear to coincide with the picture if you position it next to

the TV set.

¢ Surround speakers are best positioned to set slightly above ear level.

DOLBY

SURROUND

LEVEL

ADJUSTMENT

PROCEDURE

For

correct

SURROUND

reproduction,

sure

perform

this

adjustment.

1. Use SURROUND

MODE

switch to select DOLBY

PRO

LOGIC

SURROUND.

2. Use SPEAKER switches to turn on front, rear and center speakers.

3. Adjust MASTER

VOLUME

to a suitable listening level.

4. Select a monaural source {such as AM radio) or Dialogue portions

of movies.

5. Press BALANCE L and R switches together.

6. Press CENTER

LEVEL

+ and - switches together.

7. Press REAR LEVEL

+ and - switches together.

8. Select the CENTER MODE switch to the OFF position.

9. Adjust rear panel INPUT BALANCE knob to the position that gives

minimum volume from the front and rear speakers.

10. Select CENTER MODE (NORMAL, WIDE, PHANTOM) setting.

11. Turn on TEST TONE switch.

12. Adjust so that volume

is the same

from each speakers.

Use

BALANCE L and R switches, REAR LEVEL + and - switches, and

CENTER

LEVEL switches.

13. Turn off TEST TONE switch when finished.

14.Use AUDIO

INPUT SELECTOR

or VIDEO

INPUT SELECTOR

select your desired source.

15. Adjust the desired sound fevel by the MASTER

VOLUME.

NOTE:

* Set in the range of 12 to 15 by remote control operation from the

listening/viewing position.