3D Hobby Shop Extra SHP 47" Manuel d'assemblage - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'assemblage pour {nom_de_la_catégorie} 3D Hobby Shop Extra SHP 47". 3D Hobby Shop Extra SHP 47" 20 pages. Arf rc

Imprimer la page

Install elevator half with joiner rod onto horizontal stabilizer, sliding hinges into slots in stabilizer DO NOT

GLUE HINGES YET. Apply a generous amount of medium CA into joiner slot on second elevator.

Install second elevator onto elevator joiner rod and slide hinges into stabilizer. DO NOT GLUE HINGES

YET. Allow joiner rod to cure.

Adjust elevators left-to-right to align with stabilizer. You may notice some twist of the elevator assembly.

This will not affect flight performance. If you wish to remove any twist for cosmetic reasons, have a

helper twist the assembly slightly the opposite way, and shrink out the resulting covering wrinkles with a

heat gun. This will remove any twist.

Make sure the elevator can flex 45 degrees up and 45 degrees down without binding. Correct any

binding by leaving a slightly larger gap between the stabilizer and elevator. This is called "hinge gap" and

typically the 47" SHP needs about 1/16

inch of gap.