3D Hobby Shop Extra SHP 47" Manuel d'assemblage - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'assemblage pour {nom_de_la_catégorie} 3D Hobby Shop Extra SHP 47". 3D Hobby Shop Extra SHP 47" 20 pages. Arf rc
Imprimer la page11
Use small drill bit, small screwdriver, or end of tailwheel wire to make a hole in the rudder at the
appropriate spot and insert tailwheel wire into rudder. Check location against manual photo, and if the
wire is in the correct location, remove and put a generous amount of medium CA glue into slot. Install
wire and allow to cure.
Install rudder onto fuselage, sliding hinges into slots in rear of fuselage and vertical stabilizer. Check
alignment of bottom of rudder and fuselage as shown. Drip two large drops of thin CA glue onto each
hinge. Allow to cure.