3D Hobby Shop Extra SHP 47" Manuale di montaggio - Pagina 11

Sfoglia online o scarica il pdf Manuale di montaggio per Aerei 3D Hobby Shop Extra SHP 47". 3D Hobby Shop Extra SHP 47" 20. Arf rc

Use small drill bit, small screwdriver, or end of tailwheel wire to make a hole in the rudder at the

appropriate spot and insert tailwheel wire into rudder. Check location against manual photo, and if the

wire is in the correct location, remove and put a generous amount of medium CA glue into slot. Install

wire and allow to cure.

Install rudder onto fuselage, sliding hinges into slots in rear of fuselage and vertical stabilizer. Check

alignment of bottom of rudder and fuselage as shown. Drip two large drops of thin CA glue onto each

hinge. Allow to cure.