3D Hobby Shop Extra SHP 47" 조립 설명서 - 페이지 11
{카테고리_이름} 3D Hobby Shop Extra SHP 47"에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop Extra SHP 47" 20 페이지. Arf rc
페이지 인쇄11
Use small drill bit, small screwdriver, or end of tailwheel wire to make a hole in the rudder at the
appropriate spot and insert tailwheel wire into rudder. Check location against manual photo, and if the
wire is in the correct location, remove and put a generous amount of medium CA glue into slot. Install
wire and allow to cure.
Install rudder onto fuselage, sliding hinges into slots in rear of fuselage and vertical stabilizer. Check
alignment of bottom of rudder and fuselage as shown. Drip two large drops of thin CA glue onto each
hinge. Allow to cure.