Dixon Bayco DBC Series Instructions d'entretien et d'utilisation - Page 8

Parcourez en ligne ou téléchargez le pdf Instructions d'entretien et d'utilisation pour {nom_de_la_catégorie} Dixon Bayco DBC Series. Dixon Bayco DBC Series 13 pages. 3" dry disconnects

Imprimer la page

DBC 3" Series Dry Disconnects

20. Insert the GROOVE PIN into the hole in the LEVER until it has

gone past the gap in the LEVER and into the hole on the opposite

side of the LEVER. Do not hammer the pin into place at this time.

21. Slide the LOCK WASHER over the LEVER SCREW and apply

"Never Seize" to the LEVER SCREW.

22. Install the SCREW into the LEVER and tighten firmly to squeeze

the LEVER against the hex of the CAM SHAFT.

23. Hammer the GROOVE PIN into the LEVER until flush.

24. Turn the coupler so that you can look into the open end nearest

the LEVER.

25. Insert the COTTER PIN into the hole in the main SHAFT and

using the LEVER to rotate the CAM SHAFT as needed, completely

flair the COTTER PIN.

26. Adjust the POPPET by rotating the LEVER to the open position

and rotating the POPPET left or right to increase or decrease the

compression on the SEAL CYLINDER. The POPPET is properly

adjusted when the seal on the SEAL CYLINDER is just barely

separated from the face of the BLANK ADAPTER (about 1/32") when

the coupler LEVER is rotated to the closed position. There will be a

noticeable 'over center' feel to the lever as it enters its closed

position. The LEVER should tend to stay closed when rotated to its

closed position. If it does not, open the LEVER and readjust the

POPPET by threading it down further into the BODY then repeat this

step.

27. With the POPPET correctly adjusted, tighten the SET SCREW in

the POPPET securely against the YOKE. This requires 55 FT-LB of

torque. This is necessary to prevent the POPPET from rotating out of

adjustment.

28. Install the O-RING under the head of the POPPET SCREW.

Apply "Never Seize" to the SCREW and tighten into the POPPET.

29. With the coupler in the closed position, unlock and open the CAM

ARMS and remove the BLANK ADAPTER.

30. Install the main GASKET.

877.582.3569

DBC 3" SERIES