Dixon Bayco DBC Series Instructions d'entretien et d'utilisation - Page 7

Parcourez en ligne ou téléchargez le pdf Instructions d'entretien et d'utilisation pour {nom_de_la_catégorie} Dixon Bayco DBC Series. Dixon Bayco DBC Series 13 pages. 3" dry disconnects

Imprimer la page

8. Press new guide BUTTONS into the outside diameter of the SEAL

CYLINDER and apply a liberal coating of grease to the SEAL

CYLINDER outside diameter.

- If unit uses a PTFE NOSE SEAL, insert that NOSE SEAL

into the end of the SEAL CYLINDER.

9. Insert the BUSHING inside of the SEAL CYLINDER.

10. Place the metal SPRING GUIDE into the SPRING such that the

flange rests on top of the SPRING.

11. Place the assembled SEAL CYLINDER over the SPRING.

12. Center the BLANK ADAPTER on the SEAL CYLINDER and while

holding the CAM ARMS open, press the SEAL CYLINDER into the

BODY using an orbital motion to ease the SEAL CYLINDER

BUTTONS past the O-RING in the BODY.

13. While holding the SEAL CYLINDER securely against the

SPRING force, close the CAM ARMS. You can now release the force

on the BLANK ADAPTER.

14. Insert the POPPET through the opening in the BLANK ADAPTER

and into the SEAL CYLINDER.

15. Make sure the BUSHING is still in the hole in the BODY opposite

of the STUFFING BOX.

16. Insert the YOKE and POPPET STEM assembly through the

threaded end of the BODY and while holding the POPPET thread the

POPPET STEM into the POPPET a few turns.

17. Insert the main SHAFT through the square holes in the YOKE

and into the BUSHING in the BODY. You may need to rotate and

move the POPPET up and down in the BODY and rotate the YOKE

in order to get the end of the main SHAFT installed.

18. If the BODY is stainless steel, apply "Never Seize" to the

STUFFING BOX threads. Install the assembled STUFFING BOX

over the end of the main SHAFT and tighten into the BODY. Take

care not to damage the O-RING in the STUFFING BOX as it slides

onto the main SHAFT.

19. Install the LEVER onto the hex end of the main SHAFT. The

small gap on the main SHAFT hex, points toward the portion of the

LEVER that your hand will grip.

DBC 3" SERIES

DBC 3" Series Dry Disconnects

877.582.3569