Artistic studio Artristic Studio Easel Manuel de l'utilisateur - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Artistic studio Artristic Studio Easel. Artistic studio Artristic Studio Easel 15 pages.

Imprimer la page

Attaching white boards and canvas

stretchers by their outer edges

WARNING:

DO NOT ATTACH VERY HEAVY, LARGE, CHIPBOARD, HARDWOOD

OR PLYWOOD BOARDS

� Unlock each of the eight T-Bar arm

clamps and extend each arm fully

� This what your Hub should look

like now

� Each of the four sides of the board should

be sitting on the shelves of the T-Bar arms,

and flush up against the end brackets

� Remove the 8 pointed rods, reverse

and re-screw them back into the T-Bar

arms but do not expose the points yet

� Next, lay your canvas or white board

onto the top of the Hub, positioning the

centre of the board as close as you can over

the centre of the Hub, then start sliding

each T-Bar arm inwards towards the can-

vas/white board edges

� Now, on the underside of the canvas

or board, start re-locking all eight of

the T-Bar arm clamps

Attaching white boards and canvas

� Double check that the board is sit-

ting flush up against all eight T-Bar

shelf end brackets and then start

screwing the 8, pointed rods into

the side edges of the canvas or white

board

� Reset the Hub into the upright

position again

stretchers by their outer edges

� The pointed rods need only penetrate

the side of the canvas board by about

2mm

� Now you are ready to create your next

painting