Artistic studio Artristic Studio Easel Manuel de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Artistic studio Artristic Studio Easel. Artistic studio Artristic Studio Easel 15 pages.

Imprimer la page

How to Attach 3mm to 6mm Thick Art Boards

LOCK

THIS

KNOB

� Adjust tripod height to waist level with

the T-Bars locked into the centre archways

of the Hub. Push it down into its flat/hori-

zontal position and lock in place

� Now unlock each of the eight T-Bar

arm clamps and extend each arm fully

� Lay your board onto the Hub so that its centre is as close as you can guess to the centre of the

board, and one by one, push each T-Bar arm inwards towards the outer edges of the board

� Hold each clear safety cap up against

the points of the rods on the T bar arms

and rotate the threaded rod clockwise

until only the red plastic end is visible

and the point is inside the safety cap

� This is what your Hub should look like

How to Attach 3mm to 6mm Thick Art Boards

� Slide the board edges underneath

the red plastic ends of the pointed

rods

� This is what it will look like from un-

derneath the board. Now you are ready to

attach your working surface paper to the

front of the board

� The minimum board size you can attach when the T-Bar arms are locked onto the Hub in hori-

zontal position is 46cm x 46cm (18 ¾ inches x 18 ¾ inches). For more information regarding canvas

sizes,you can attach, go to page 6.

� The maximum size is 90cm x 90cm (35 ½ inches x 35 ½ inches)

PLEASE NOTE: Do not attach boards larger than 90cm x 90cm (35 ½ inches x 35 ½ inches) and

always avoid excessively heavy boards. Smaller boards can be attached by using only three or two of the

T-Bar arms.

� For more ways to lock the T-Bar arms to the Hub, refer to page 23.

� Check that the end of each T-Bar arm

shelf is pushed up tightly against the

red plastic caps, then one by one, lock

all 8 of the clamps under the board

� If your art board is very thin, place a

piece of kitchen washing up foam onto

the centre of the Hub. This will push

your board firmly against the 8 red-

capped rods