Artistic studio Artristic Studio Easel Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori Kamera Artistic studio Artristic Studio Easel. Artistic studio Artristic Studio Easel 15 halaman.

Halaman Cetak

How to Attach 3mm to 6mm Thick Art Boards

LOCK

THIS

KNOB

� Adjust tripod height to waist level with

the T-Bars locked into the centre archways

of the Hub. Push it down into its flat/hori-

zontal position and lock in place

� Now unlock each of the eight T-Bar

arm clamps and extend each arm fully

� Lay your board onto the Hub so that its centre is as close as you can guess to the centre of the

board, and one by one, push each T-Bar arm inwards towards the outer edges of the board

� Hold each clear safety cap up against

the points of the rods on the T bar arms

and rotate the threaded rod clockwise

until only the red plastic end is visible

and the point is inside the safety cap

� This is what your Hub should look like

How to Attach 3mm to 6mm Thick Art Boards

� Slide the board edges underneath

the red plastic ends of the pointed

rods

� This is what it will look like from un-

derneath the board. Now you are ready to

attach your working surface paper to the

front of the board

� The minimum board size you can attach when the T-Bar arms are locked onto the Hub in hori-

zontal position is 46cm x 46cm (18 ¾ inches x 18 ¾ inches). For more information regarding canvas

sizes,you can attach, go to page 6.

� The maximum size is 90cm x 90cm (35 ½ inches x 35 ½ inches)

PLEASE NOTE: Do not attach boards larger than 90cm x 90cm (35 ½ inches x 35 ½ inches) and

always avoid excessively heavy boards. Smaller boards can be attached by using only three or two of the

T-Bar arms.

� For more ways to lock the T-Bar arms to the Hub, refer to page 23.

� Check that the end of each T-Bar arm

shelf is pushed up tightly against the

red plastic caps, then one by one, lock

all 8 of the clamps under the board

� If your art board is very thin, place a

piece of kitchen washing up foam onto

the centre of the Hub. This will push

your board firmly against the 8 red-

capped rods