- ページ 9
カメラアクセサリー Artistic studio Artristic Studio EaselのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Artistic studio Artristic Studio Easel 15 ページ。
ページを印刷するHow to Attach 3mm to 6mm Thick Art Boards
1
LOCK
THIS
KNOB
� Adjust tripod height to waist level with
the T-Bars locked into the centre archways
of the Hub. Push it down into its flat/hori-
zontal position and lock in place
3
� Now unlock each of the eight T-Bar
arm clamps and extend each arm fully
5
� Lay your board onto the Hub so that its centre is as close as you can guess to the centre of the
board, and one by one, push each T-Bar arm inwards towards the outer edges of the board
16
2
� Hold each clear safety cap up against
the points of the rods on the T bar arms
and rotate the threaded rod clockwise
until only the red plastic end is visible
and the point is inside the safety cap
4
� This is what your Hub should look like
How to Attach 3mm to 6mm Thick Art Boards
6
� Slide the board edges underneath
the red plastic ends of the pointed
rods
8
� This is what it will look like from un-
derneath the board. Now you are ready to
attach your working surface paper to the
front of the board
10
� The minimum board size you can attach when the T-Bar arms are locked onto the Hub in hori-
zontal position is 46cm x 46cm (18 ¾ inches x 18 ¾ inches). For more information regarding canvas
sizes,you can attach, go to page 6.
� The maximum size is 90cm x 90cm (35 ½ inches x 35 ½ inches)
PLEASE NOTE: Do not attach boards larger than 90cm x 90cm (35 ½ inches x 35 ½ inches) and
always avoid excessively heavy boards. Smaller boards can be attached by using only three or two of the
T-Bar arms.
� For more ways to lock the T-Bar arms to the Hub, refer to page 23.
7
� Check that the end of each T-Bar arm
shelf is pushed up tightly against the
red plastic caps, then one by one, lock
all 8 of the clamps under the board
9
� If your art board is very thin, place a
piece of kitchen washing up foam onto
the centre of the Hub. This will push
your board firmly against the 8 red-
capped rods
17