1010music Toolbox Manuel de l'utilisateur - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} 1010music Toolbox. 1010music Toolbox 16 pages.
Également pour 1010music Toolbox : Manuel de démarrage rapide (2 pages)
Imprimer la page
Step Count
The number of steps in the sequence. The
number of boxes on the screen will
remain the same, but if a value lower than
32 is selected, the sequencer will only
move through the number of steps
selected. This parameter can be
modulated.
Clk Source
This parameter allows you to use an
alternative input as the clock signal. By
default, the toolbox internal clock (INT)
will be used.
MIDI Ch
The MIDI channel that this sequencer will
use for output.
Quant Size
Defines precisely when to restart the
sequence when using the internal clock.
When the sequence ends, toolbox will
wait until the start of the next Quant Size
interval to restart the sequence.
MIDI Port
Controls which of toolbox's MIDI Output
jacks will be used for the output of this
sequencer. Multiple Note Sequencers
may use the same MIDI Port.
Transpose
Shifts the This parameter can be
modulated.
Note:
If a value of a Note Sequencer parameter is changed during playback of the sequence, the change
•
will take effect at the start of the next loop through the sequence.
Use the LFO Function Generators
Toolbox can generate three low frequency oscillation (LFO) signals. These outputs play out the Function
Generator Output Jacks 5 through 7. The output range for these signals is -5V to +5V. To configure an LFO:
1.
From the Main screen, touch one of the LFO buttons in the right column to display the LFO Parameters
screen.
2.
Use the control knobs to adjust the values of the following parameters:
Parameter
Description
Waveform
Choose the desired
Oscillator.
Depth
The amount or
amplitude of the
LFO.
Rate
The frequency of the
LFO from about
0.1Hz to 12 Hz. When
Beat Sync
this specifies the rate
in beats and
measures.
11/23/17 10:32 AM
Range of Values
Saw
•
Rev Saw
•
Triangle
•
Pos Tri
•
Square
•
0 to 100%
0 to 100%
is
,
1/64, 1/32T, 1/32, 1/16T, 1/16, 1/8T, 1/8,
On
1/4T, ¼, 1/2T, ½, 1 bar, 2 bars
(T= Triplet)
Digital Heart – Analog Soul
Toolbox User Manual
1 to 32
INT, EXT1, EXT2, EXT3,
GATE1, GATE2, GATE3,
GATE4
1 through 16
1/64, 1/32T, 1/32, 1/16T,
1/16, 1/8T, 1/8, 1/4T, ¼,
1/2T, ½, 1 bar, 2 bars
(T= Triplet)
1 through 4
-48 to 48
Pos Square
•
Sine
Pos Sine
•
Random
•
or
Copyright 1010music LLC 2017
Figure 1 2: Note
Sequencer P a ra meters
P age 2
Figure 1 3: LFO
P arameters Sc reen
P. 11