Donmar SH-R-01 Panduan Petunjuk Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pemanas Donmar SH-R-01. Donmar SH-R-01 9 halaman. Seat heaters universal: dual temperature carbon fiber: twin comfort pads

Halaman Cetak

Installation Instructions

1. Ensure that the vehicle is on a level surface in "Park" & with the hand brake engaged.

2. Disconnect the car's battery or ensure that the work area is well grounded.

3. Unplug any wires which may be attached / harnessed to the underside of the vehicle's seat. Proceed to unbolt

the seat from the vehicle's floor.

4. Carefully remove the seat out of the vehicle to allow for easier access to the vehicle's seat & seat cover trim

"J" clips.

5. Carefully remove the seat covers off of the seat by detaching the "J" clips which bind the Backrest Cover

together. Then, detach the clips which secure the seat bottom seat cover. These clips secure the cover at the base /

perimeter at the bottom of the seat.

6. Place the backrest pad (10.5" x 19") & the seat bottom heating pad (10.5" x 19") against the respective

backrest & seat bottom. Align the heating pads against the seat & "Mark" the listing attachment area to be cut to

allow for the re-installation of the backrest & Cushion covers.

7. Carefully cut no more than 2 holes horizontally or 2 holes vertically from each of the seat heater pads. The

diameter of the each hole should not exceed 1 inch.

Note: The seat heater pads may also be trimmed in length to accommodate a variety of seating styles & listing

locations.

Example – If the seat bottom pad length at 18" is too long then simply trim the heating pad with a pair of scissors

to achieve the desired length.

Do Not: Cut the heating pads widthwise!!! This will render the seat heater useless and void the warranty.

8. Remove the protective backing from the back side of the seat heating pad and carefully adhere the pad to the

seat at the desired location.

9. At this point the holes cut in the pad should align with your identified key listing attachment locations.

Note: Older style listings = wire rod and listing sleeve (requires hog rings for the installation). Newer

style listings incorporate Velcro attachments. For older styles listings secure one of the provided

strips of adhesive tape around the wire listing rod to insulate it.

10. Locate an onboard power source that is able to deliver a continuous 10 Amp current. This source may be

located at your accessory panel, accessory outlet, etc. Consult with the Owner's Vehicle Manual to ensure an

appropriate location as a source of power source.

11. Once the power source is located extend the wiring harness underneath the carpeting to be able to access this

power source. (Never install the wire directly under where the occupant's feet would rest)

12. Find a suitable location for your seat heater switches either at the side of the seat, front dash or floor mounted

center console in between the driver and passenger seats.

13. At the desired location drill a 13/16" or 21mm hole and pull the main wiring connector to be attached to the

seat heater switch harness connector through the hole. Attach the switch connector with the main wiring

connector and push everything back through the hole and make sure to push the switch snuggly into the hole until

you hear a "click".

03 Jan 2009