Donmar SH-R-01 Panduan Petunjuk Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pemanas Donmar SH-R-01. Donmar SH-R-01 9 halaman. Seat heaters universal: dual temperature carbon fiber: twin comfort pads

Halaman Cetak

14. Re-install the vehicle's seats and attach the connector which you secured underneath the seat with the

connector pulled up through the carpeting. Make sure to securely re-bolt the vehicle's seats to the vehicle's floor.

15. At this point connect the seat heater lead wires to the previously identified safe power source and secure a

good ground base.

16. Make sure to connect your battery terminals and start your ignition.

17. Press the seat heater switch to the upward position for a desired high setting. The middle setting is the Neutral

or "OFF" position. Press the switch down to the lower position to engage the Low temperature setting.

Caution: If at any time you feel that the seat heaters are too hot or causing dizziness due to overheating please

turn off the seat heater and / or take your vehicle to the side of the road and carefully exit the vehicle and wait to

regain composure. If you feel that the seat heaters are malfunctioning please consult with your Professional

Installer.

OCS (Occupant Classification System) / OPDS (Occupant Position Detection System) devices

There are generally three set-ups for sensors.

1. The sensor is located under the seat foam core on the frame.

2. The sensor is located within the seat foam core.

3. The sensor is located on the top surface of either the seat bottom or back foam core.

Historically, Toyota and Honda install sensors on the top surface of the seat bottom and back rest respectively.

Honda continues to deliver the Odyssey EX-L and the Touring equipped with seat heaters.

Honda installs its OPDS (sensor) on the top surface of the passenger backrest.

As a result, it provides Heat for the Bottom only and does not heat the backrest portion of the seat.

Toyota, Hyundai, Kia, BMW etc ... equip their seats in the similar way to Honda with a difference

The big difference being that the sensor location is on top of the seat bottom surface not the backrest.

Likewise, they only heat the section which is not equipped with a sensor.

Example - A Toyota Sienna with a passenger side sensor for airbags features a heated backrest only.

Summary:

Follow the example of what the factory does.

Do not place a seat heater pad on top of the OCS / OPDS sensor.

Instead, prepare to install the pad onto the foam core which is not equipped with the sensor.

Simply unplug one of our heating pads from the main harness.

Make sure that the remaining pad is plugged into the connector which provides dual temperature control.

Remove the adhesive backing from the pad and adhere it to the appropriate non-OCS foam section.

Continue with the balance of the installation process as normal.

03 Jan 2009

Installation Instructions – Continued