Akuvox A05 Series Panduan Cepat - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Cepat untuk Pengontrol Akses IP Akuvox A05 Series. Akuvox A05 Series 8 halaman.

1.2 Without embedded gang box in the wall

2.Step 2: Device Installation

2.1 Device Installation without Digital Forehead or Wrist Temperature Detector

Take out the device along

with the back cover, cable

locking plate, rubber plug

and corresponding screws.

According to the position of the

cable, put the wall-mounting

bracket closely on to the wall

and mark the four positioning

holes, while making sure that

relative positions between

wall-mounting bracket and wire

hole are correct.

Note: The positioning holes

should be marked in the center

of the holes.

Fix the wall-mounting

bracket with four ST4x20

screws.

Lead the wires from the wall-mount bracket and

the detector through the square hole on the back

cover, connecting them to the corresponding

interface of the main board.

Select a suitable size rubber plug to push all the

cables into the back cover. Fix cable locking plate

to the back cover with two M2.5x6 screws.

E16/A05

Take oﬀ the

wall-mounting and

drill the four marked

positioning holes

and the wire holes

using 5 mm hand

drills.

Insert four plastic wall

anchors into the holes.

Fasten the back cover with

four Torx screws using the

Torx wrench attached.