astra telematics AT110V5 Panduan Instalasi

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk GPS astra telematics AT110V5. astra telematics AT110V5 5 halaman. Advanced vehicle tracking device
Juga untuk astra telematics AT110V5: Panduan Pengguna (11 halaman)

Halaman Cetak

Version 1.0

AT110V5 Installation Guide

1. Install the Antenna

Choose a suitable location for the antenna, with a good 'view' of the sky for optimum GPS

reception, according to the antenna type supplied:

a. AE001 – under the dashboard, adhesive side down

b. AE002 – roof mounted, requiring a hole in the panel

c. AE003 – windscreen mounted, adhesive to the glass, typically in the bottom corner of

the screen

d. AE004 – separate GPS and GSM antennas. GPS to be fitted adhesive side down and

GSM to be fitted at least 0.5m away, avoiding close proximity to metal or

loudspeakers

2. Plug-in the antenna GSM and GPS to the corresponding connectors on the

AT110

Apply direct force when connecting and disconnecting the antennas. Do not waggle from

side to side or apply excessive sideways force, to avoid damage to the device.

3. Hook up the power and ignition electrical connections using the CB110 cable

a. Connect the BLACK wire to GND and the RED wire to a PERMANENT +12V/+24V

vehicle power source. Connect the ignition sense input (digital input 1) to an ignition

switched 12/24V signal (i.e. something that only goes live when the vehicle ignition is

ON)

i. RED

ii. BLACK

iii. WHITE

PLUG IN ANTENNAS HERE

PERMANENT +12 / +24V

GROUND

IGNITION SWITCHED +12/24V

1A FUSED