astra telematics AT110V5 설치 매뉴얼

{카테고리_이름} astra telematics AT110V5에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. astra telematics AT110V5 5 페이지. Advanced vehicle tracking device
astra telematics AT110V5에 대해서도 마찬가지입니다: 사용자 설명서 (11 페이지)

페이지 인쇄

Version 1.0

AT110V5 Installation Guide

1. Install the Antenna

Choose a suitable location for the antenna, with a good 'view' of the sky for optimum GPS

reception, according to the antenna type supplied:

a. AE001 – under the dashboard, adhesive side down

b. AE002 – roof mounted, requiring a hole in the panel

c. AE003 – windscreen mounted, adhesive to the glass, typically in the bottom corner of

the screen

d. AE004 – separate GPS and GSM antennas. GPS to be fitted adhesive side down and

GSM to be fitted at least 0.5m away, avoiding close proximity to metal or

loudspeakers

2. Plug-in the antenna GSM and GPS to the corresponding connectors on the

AT110

Apply direct force when connecting and disconnecting the antennas. Do not waggle from

side to side or apply excessive sideways force, to avoid damage to the device.

3. Hook up the power and ignition electrical connections using the CB110 cable

a. Connect the BLACK wire to GND and the RED wire to a PERMANENT +12V/+24V

vehicle power source. Connect the ignition sense input (digital input 1) to an ignition

switched 12/24V signal (i.e. something that only goes live when the vehicle ignition is

ON)

i. RED

ii. BLACK

iii. WHITE

PLUG IN ANTENNAS HERE

PERMANENT +12 / +24V

GROUND

IGNITION SWITCHED +12/24V

1A FUSED