Amprobe WT-30 Panduan Pengguna - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Alat Ukur Amprobe WT-30. Amprobe WT-30 17 halaman. Salinity meter

TROUBLE SHOOTING

Power On But No Display

• Make sure you press power key more than 100 mS.

• Check the battery conditions and replace if

necessary

• Move batteries away for one minute and then

re-install.

Display Disappear

• Check whether the low battery icon is appeared

before the display is off. If yes, replace with new

batteries

Air Bubbles Adhere On Electrode

• Stir the electrode completely and better to dip

the electrode into solution at oblique angle. After

soaking the electrode for 15~30 minutes, inspect

the electrode carefully to make sure no bubbles

adhere.

• If air bubbles still exist, tap the bottom of the

container gently and stir the electrode to remove

the air bubbles. If above method are not working,

remove the electrode out of solution and blow at

the electrode to remove the air bubbles

Error Code

Parameter: Salinity

"- - -"

Meter is in manual range 1 however the

conductivity measured value is higher than

10.0ppt.

• Press "p" more than 2 seconds to change

the range to range 2 or to auto ranging.