Carl Wittkopp GatorSignal Plus Instruksi Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Instruksi Instalasi untuk Peralatan Perekaman Carl Wittkopp GatorSignal Plus. Carl Wittkopp GatorSignal Plus 8 halaman.

Halaman Cetak

Installation instruction GatorSignal Plus

3.1.2 Ouptuts

Bolt position

Opening delay active

Release window active

Opening window active

4 Plug position

All locks within the Gator series are equipped with an 8-pin plug to connect to the "GatorSignal Plus" box.

4.1 Gator 2000

4.3 Gator 5000

GatorSignal Plus (8-pin)

Connect the cable to the according plug for the "Gator Signal Plus" box.

GatorSignal Plus (8-pin)

For signalling the lock's bolt position. The contact is active

when the bolt reaches or leaves the closed position.

Note:

If the bolt position should change while the lock is in

standby mode, i.e. with latch bolt locks, the switching

status changes only when the lock is active again.

Silent alarm – By entering the alarm code (last code

number freely adjustable) an alarm signal is triggered and

sent to the burglar alarm system. The lock opens with the

alarm code.

When the opening delay is started the according output

is triggered. The signal can be used for signal lights for

example.

If an opening delay is activated, the according output is

switched. The signal can then be used for i.e. signal lights.

The lock can be opened after the opening delay has en-

ded. This is signaled by the according output.

4.2 Gator 3000/3010

4.4 Gator 6000/8000/9000

GatorSignal Plus (8-pin)