Bose SoundTouch Panduan Servis - Halaman 32

Jelajahi secara online atau unduh pdf Panduan Servis untuk Konverter Media Bose SoundTouch. Bose SoundTouch 39 halaman. Wireless pedestal
Juga untuk Bose SoundTouch: Panduan Pemilik (33 halaman), Panduan Pemilik (32 halaman), Panduan Memulai Cepat (2 halaman), Manual (9 halaman), Panduan Pemilik (20 halaman), Panduan Pemilik (32 halaman), Panduan Memulai Cepat (5 halaman), Mulai dari Sini Manual (20 halaman), Panduan Memulai Cepat (2 halaman), Panduan Pemilik (18 halaman), Panduan Memulai Cepat (5 halaman), Panduan Memulai Cepat (2 halaman)

Halaman Cetak
Bose SoundTouch Panduan Servis
SoundTouch™ Wireless Pedestal

TAP Command Setup

Equipment Required:
Hardware
•
Computer w/serial port
•
Wave
®
Music system III
•
RS232 to TTL converter
•
®
Lifestyle
ETAP Cable, P/N 264565
Software
•
TeraTerm terminal emulator (Download at
http://sourceforge.jp/projects/ttssh2/)
TAP commands are sent to the SoundTouch
wireless pedestal by connecting to the
SERVICE connector on the back of the
pedestal.
An ETAP cable and RS232 to TTL Converter
are required for this communication. The
ETAP cable is available from Bose
number above). The RS232 to TTL Con-
verter is made by B+B electronics, model
number 232LPTTL. It can be purchased
online at http://www.bb-elec.com.
B+B Electronics model 232LPTTL
RS232 to TTL converter
TAP commands are needed for the following
procedures:
A. Wi-Fi Test
B. Serial Number Programing
C. Setting Wi-Fi Country Code
TAP COMMAND SETUP
®
(see part
32
1. Tera Term Terminal USB Setup
Tera Term is a terminal emulator and can
be downloaded at http://sourceforge.jp/
projects/ttssh2/. It is the interface used to
send TAP commands to the SoundTouch
wireless pedestal.
1.1 Connect the SoundTouch wireless
pedestal to the Wave
the Bose link cable on the pedestal.
1.2 Connect the Wave
AC power.
1.3 Connect the SoundTouch wireless
pedestal to the computer.
•
Connect the RS-232 to TTL converter to
the COM port on the PC.
•
Connect the TAP cable to the RS-232 to
TTL converter.
•
Plug the other end of the TAP cable into
the SERVICE jack on the back of the
SoundTouch wireless pedestal.
2. Teraterm Setup
2.1 Launch a Tera Term terminal window
and select serial communication and port
as shown below and on the next page.
®
Music system III using
®
Music system III to