3M Litmann Quality 3100 Petunjuk Manual - Halaman 2
Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Peralatan Medis 3M Litmann Quality 3100. 3M Litmann Quality 3100 16 halaman. Mining cable splice kit
Juga untuk 3M Litmann Quality 3100: Panduan Memulai Cepat (2 halaman)
Halaman Cetak
1.0
Cutting And Cable Preparation
1.1
Square cut cable ends to be spliced.
1.2
Split cable approximately 12" (305 mm) between phases.
1.3
If using cable types G or G-GC, pull grounds and ground check conductors out
and tape to cable jacket behind split.
1.4
If using two-conductor cable, cut one lead approximately 6" (150 mm) from end
of cable, leave other conductor approximately 12" (305 mm). Cut corresponding
conductors to match.
Scuff &
Clean
4"
(100 mm)
Instructions For Flat Cables
3M
Temflex
Electrical Vinyl Tape 1700P
™
™
Figure 1
(150 mm)
1" (25 mm)
taper
Figure 2
Scotch
Heavy Duty Mining Tape 31
®
Scotch
Linerless Rubber Splicing Tape 130C
®
3M
Temflex
™
Scotch
Linerless Rubber Splicing Tape 130C
®
3M
Temflex
™
™
12"
(305 mm)
9"
(230 mm)
6"
2
Vinyl Electrical Tape 1700P
™
Electrical Vinyl Tape 1700P
Required Connector Length
78-8127-6830-3-C