3M Litmann Quality 3100 사용 설명서 - 페이지 2

{카테고리_이름} 3M Litmann Quality 3100에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M Litmann Quality 3100 16 페이지. Mining cable splice kit
3M Litmann Quality 3100에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

3M Litmann Quality 3100 사용 설명서
1.0
Cutting And Cable Preparation
1.1
Square cut cable ends to be spliced.
1.2
Split cable approximately 12" (305 mm) between phases.
1.3
If using cable types G or G-GC, pull grounds and ground check conductors out
and tape to cable jacket behind split.
1.4
If using two-conductor cable, cut one lead approximately 6" (150 mm) from end
of cable, leave other conductor approximately 12" (305 mm). Cut corresponding
conductors to match.
Scuff &
Clean
4"
(100 mm)
Instructions For Flat Cables
3M
Temflex
Electrical Vinyl Tape 1700P
Figure 1
(150 mm)
1" (25 mm)
taper
Figure 2
Scotch
Heavy Duty Mining Tape 31
®
Scotch
Linerless Rubber Splicing Tape 130C
®
3M
Temflex
Scotch
Linerless Rubber Splicing Tape 130C
®
3M
Temflex
12"
(305 mm)
9"
(230 mm)
6"
2
Vinyl Electrical Tape 1700P
Electrical Vinyl Tape 1700P
Required Connector Length
78-8127-6830-3-C