3M Litmann Quality 3100 사용 설명서 - 페이지 3
{카테고리_이름} 3M Litmann Quality 3100에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M Litmann Quality 3100 16 페이지. Mining cable splice kit
3M Litmann Quality 3100에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄
1.5
If using three-conductor cable, stagger leads approximately 6" (150 mm), 9"
(230 mm), and 12" (305 mm) from end of split. Cut corresponding conductors
to match.
Scuff &
Clean
4"
(100 mm)
1.6
Remove jacket and phase insulation for one-half butt connector length or two
parallel connector lengths from each phase end.
1.7
Taper jacket approximately 1" (25 mm). Taper or bevel ends of insulation to
conductor.
1.8
Scuff and clean 4" (100 mm) of cable jacket beyond each taper or split end.
1.9
Cut ground and ground check conductor to lie in between connections of phases.
2.0
Install Connectors
2.1
Join conductors one at a time using proper connectors (butt, parallel or modified
crow's foot) and crimping tool.
Note: Insulate each conductor in sequence before connecting the next conductor,
ground, or ground check.
78-8127-6830-3-C
9"
(230 mm)
6"
(150 mm)
1" (25 mm)
taper
Figure 3
Figure 4
3
12"
(305 mm)
Required Connector Length