DUCTFORMER TDFC Manual Operasi dan Prosedur - Halaman 5

Jelajahi secara online atau unduh pdf Manual Operasi dan Prosedur untuk Peralatan Industri DUCTFORMER TDFC. DUCTFORMER TDFC 12 halaman. Power brake

3.2. Unloading Procedure

 When unloading the machine off of the transport vehicle, the machine is

best handled by lifting the machine under the frame. Make sure Forks

extend through to the other side of the machine.

 Move the machine to the desired location and visually inspect machine

thoroughly before installing power.

 Never LIFT the machine by anything other than under the frame, this

would result in excessive damage to the machine and void warranty

 After moving the machine to desired location, level and secure the

machine to the floor as required.

3.3. Electrical Connections

 Supply 110 or 220 Volt single phase electrical service to the electrical

enclosure (Depending upon which model you have), in accordance with

National and Local Electrical Codes. This machine is offered in both 110

Volt and 220 Volt versions

ONLY UPON THE SATIFACTORY COMPLETION OF ALL THE ABOVE CHECKS

AND PERFORMANCE OF INITIAL INSTALLATION PROCEDURES SHOULD THE

MACHINE BE POWERED UP OR RELEASED FOR PRODUCTION USE.

4. Schematics

Pneumatic Schematic: See end of manual

Electrical Schematics: See end of manual

No repair or maintenance should be performed while the machine is running

or capable of running. Proper LOCKOUT/TAGOUT Procedures should be

followed. Turn all machine controls off before shutting off the Main Electrical

Disconnect to prevent startup when POWER is restored. Disconnect all

Electrical POWER at the Main Electrical Disconnect before performing any

maintenance or repairs to the Machine. It is important to realize that

cylinders will eventually bleed down and release or lower their loads. When

OPERATING and PROCEDURES MANUAL

Page 5 of 12

TDFC POWER BRAKE