DUCTFORMER TDFC Manual Operasi dan Prosedur - Halaman 6

Jelajahi secara online atau unduh pdf Manual Operasi dan Prosedur untuk Peralatan Industri DUCTFORMER TDFC. DUCTFORMER TDFC 12 halaman. Power brake

working around such items, blocks should be used to prevent unintentional

movements. After a repair remove the blocks and check the entire machine

carefully to determine proper reassembly before POWER is restored.

 Note: The machine is supplied with bearings pre lubricated; however the

bearings should be lubricated after every 500 hours of running time.

 The machine should be inspected for dirt and debris that may have

collected during Daily Usage.

 All bolts should be checked for tightness every 6-months.

6. General Construction, Factory Settings and Adjustments

 This machine is designed for a maximum of 16 gauge Steel.

 Do not exceed the maximum material thickness for the machine.

 The machine has been adjusted at factory and should not require any

changes.

 The TDFC Brake is exclusively designed as a one (1) man operation.

Failure to follow this precaution can result in serious injury.

6.2. Folder Adjustments

 The Folder pivot position is located with pillow bearing blocks.

Adjustment bolts push the bearing blocks back toward the rear of the

machine, tightening the bend. To adjust, first remove the small guards

around the pivot mechanisms, then loosen the two bolts that fasten the

pillow block bearing to the table and rotate adjustment bolt to obtain

desired brake.

 The Folder stop position is determined by the stop bolts located on the

overhead press bar. Loosen the jam nuts and adjust to set desired

brake angle.

OPERATING and PROCEDURES MANUAL

Page 6 of 12

TDFC POWER BRAKE