DUCTFORMER TDFC Manual Operasi dan Prosedur - Halaman 8

Jelajahi secara online atau unduh pdf Manual Operasi dan Prosedur untuk Peralatan Industri DUCTFORMER TDFC. DUCTFORMER TDFC 12 halaman. Power brake

OPERATING and PROCEDURES MANUAL

TDFC POWER BRAKE

Button Description

The electrical enclosure has all of the main control selectors and buttons to operate the

system. The following is a description of their individual functions.

POWER ON/OFF – This selector switch with green light indicates that power is supplied

to the machine and ready for operation

CYCLE START (FOOT PEDAL): – This foot switch controls the automatic feed cycle of

the Power Brake operation. When depressed, the press bar will come down to clamp

the part in place, next the folder will swing up. After this operation the folder will swing

back down and the press bar will retract. Machine must be selected to AUTO mode.

MANUAL/AUTO: - This selector switch will set the desired operation mode for the

machine. Manual mode must be selected for the various manual push button

operations. Automatic mode must be selected when running production.

PRESS DOWN – This push button operates simultaneously with the MANUAL CLAMP

button to operate the press bar. Press and hold the PRESS DOWN button until the

press is run all the way down; then without releasing simultaneously press the

MANUAL CLAMP button to hold the press in the clamping position. After releasing

both buttons press the PRESS DOWN button again to move the press back to the up

position. Machine must be selected to MANUAL mode.

Page 8 of 12