DUCTFORMER TDFC Manual Operasi dan Prosedur - Halaman 4

Jelajahi secara online atau unduh pdf Manual Operasi dan Prosedur untuk Peralatan Industri DUCTFORMER TDFC. DUCTFORMER TDFC 12 halaman. Power brake

1. General Information

The TDFC Power Brake is designed to operate in either Automatic or Manual Mode.

The Manual Mode is operated from a control box mounted on the front of the machine.

A foot operated switch operates the machine in Automatic Mode. A programmable logic

controller is mounted inside the electrical enclosure to control the machine operation

while in automatic mode. In either mode the machine is exclusively a one (1) man

operation. Unintended use, operator oversight and failure to operate in accordance with

these instructions can result in severe injuries.

The Power Brake performs two operations. First the press bar with upper die is driven

down with pneumatic cylinders to clamp the part in place. Next the folding assembly

swings up to brake the part. The operation can be performed three times to produce a

full wrapper.

 Visibly check machine for possible shipping damage.

 If damage is evident, insist on a notation on the freight bill and photo

document the damage immediately along with a hand written description

of apparent damage.

 If repairs are necessary, contact Ductformer by phone at 314-631-1416

you may be requested to E-Mail or Fax your damage documentation to

Ductformer.

 Fax – 314-631-3003

 Do Not place damaged equipment under power until proper repairs have

been made by a qualified service technician.

OPERATING and PROCEDURES MANUAL

Page 4 of 12

TDFC POWER BRAKE