Duerkopp Adler 550-12-12 Panduan Petunjuk Instalasi - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Mesin Jahit Duerkopp Adler 550-12-12. Duerkopp Adler 550-12-12 6 halaman.
Juga untuk Duerkopp Adler 550-12-12: Panduan Petunjuk Pengoperasian (15 halaman)
Halaman Cetak
2.2 Mounting the Thread Stand
2.3 Checking the V-belt Tension
4
Mount the thread stand on the table top as shown in the sketch above.
After transport the V-belt tension set at the factory is to be checked.
The V-belt 1 must be so tensioned that it can be pressed in at the
center by about 10 mm under finger pressure.
Correcting V-belt tension:
–
Loosen the nuts 2.
–
Swing the sewing drive 3 until the desired V-belt tension is
reached.
–
Tighten the nuts 2 again.
1
2
3