- ページ 4

ミシン Duerkopp Adler 550-12-12のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Duerkopp Adler 550-12-12 6 ページ。
Duerkopp Adler 550-12-12 にも：取扱説明書 (15 ページ)

2.2 Mounting the Thread Stand

Mount the thread stand on the table top as shown in the sketch above.

After transport the V-belt tension set at the factory is to be checked.

The V-belt 1 must be so tensioned that it can be pressed in at the

center by about 10 mm under finger pressure.

Correcting V-belt tension:

–

Loosen the nuts 2.

–

Swing the sewing drive 3 until the desired V-belt tension is

reached.

–

Tighten the nuts 2 again.