Duerkopp Adler 550-767 Panduan Petunjuk Instalasi - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Mesin Jahit Duerkopp Adler 550-767. Duerkopp Adler 550-767 18 halaman. Engineered work station for side airbag tearing seam
Juga untuk Duerkopp Adler 550-767: Petunjuk Pemasangan (2 halaman)
Halaman Cetak
5.
Lubrication
5.1 Topping up with oil
5.2 Adjusting hook lubrication
Top up the oil reservoir using DA-10 lubricating oil or only or an
equivalent oil with the following specification:
–
Viscosity at 40°C:
–
Flashpoint:
DA-10 is available from DÜRKOPP ADLER AG retail outlets
(see operating instructions).
–
Unscrew the oil-filler cap 2 and top up with oil.
–
Check the oil level at sight glass 1.
The oil level must be between " EMPTY " und " FULL".
–
Replace the oil-filler cap 2.
Remove any oil which has overflowed into the oil collector.
CAUTION:
In order to ensure that the hook is properly lubricated during the
running-in period, a relatively large quantity of oil is set prior to
despatch.
This setting should be checked and adjusted after the running-in
period.
See also the Operating or Service instructions.
2
1
2
10 mm
/s
150 °C
2
11