Duerkopp Adler 550-767 Інструкція з монтажу Посібник з монтажу - Сторінка 15
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Швейна машина Duerkopp Adler 550-767. Duerkopp Adler 550-767 18 сторінок. Engineered work station for side airbag tearing seam
Також для Duerkopp Adler 550-767: Інструкція з монтажу (2 сторінок)
Друкувати сторінку
5.
Lubrication
5.1 Topping up with oil
5.2 Adjusting hook lubrication
Top up the oil reservoir using DA-10 lubricating oil or only or an
equivalent oil with the following specification:
–
Viscosity at 40°C:
–
Flashpoint:
DA-10 is available from DÜRKOPP ADLER AG retail outlets
(see operating instructions).
–
Unscrew the oil-filler cap 2 and top up with oil.
–
Check the oil level at sight glass 1.
The oil level must be between " EMPTY " und " FULL".
–
Replace the oil-filler cap 2.
Remove any oil which has overflowed into the oil collector.
CAUTION:
In order to ensure that the hook is properly lubricated during the
running-in period, a relatively large quantity of oil is set prior to
despatch.
This setting should be checked and adjusted after the running-in
period.
See also the Operating or Service instructions.
2
1
2
10 mm
/s
150 °C
2
11