Danfoss VLT MCD 200 Petunjuk Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Pengontrol Danfoss VLT MCD 200. Danfoss VLT MCD 200 5 halaman. Usb module
Juga untuk Danfoss VLT MCD 200: Panduan Petunjuk Instalasi (17 halaman), Panduan Petunjuk Instalasi (6 halaman)

Halaman Cetak
Danfoss VLT MCD 200 Petunjuk Instalasi
Configuration
6. Identify the USB Serial Port assignment by checking Control panel > System > Hardware >
Device Manager> Ports (COM & LPT).
N.B.!:
If the USB port is not shown, disconnect then reconnect the cable. If the problem
persists, restart your PC.
7. Open WinMaster and change the Network Settings to:
Protocol:
Baud rate:
Serial Port:
8. Apply control voltage to the soft starter. Bring WinMaster on-line, then Search for Network
Starters.
N.B.!:
The starter may trip on Starter Comms while the Master is off-line. Reset the soft starter
and place the Master on-line.
N.B.!:
The drivers will configure the USB port that the module is connected to. You must use
the same physical USB port every time you connect the module to the PC.
AP Binary or AP ASCII
9600
Use the serial port number identified above
MI.17.C1.02 - VLT
®
is a registered Danfoss trademark
MCD USB Module Instructions
4