Danfoss VLT MCD 200 Installatie-instructies - Pagina 4

Blader online of download pdf Installatie-instructies voor {categorie_naam} Danfoss VLT MCD 200. Danfoss VLT MCD 200 5 pagina's. Usb module
Ook voor Danfoss VLT MCD 200: Handleiding voor installatie-instructies (17 pagina's), Handleiding voor installatie-instructies (6 pagina's)

Configuration

6. Identify the USB Serial Port assignment by checking Control panel > System > Hardware >

Device Manager> Ports (COM & LPT).

N.B.!:

If the USB port is not shown, disconnect then reconnect the cable. If the problem

persists, restart your PC.

7. Open WinMaster and change the Network Settings to:

Protocol:

Baud rate:

Serial Port:

8. Apply control voltage to the soft starter. Bring WinMaster on-line, then Search for Network

Starters.

N.B.!:

The starter may trip on Starter Comms while the Master is off-line. Reset the soft starter

and place the Master on-line.

N.B.!:

The drivers will configure the USB port that the module is connected to. You must use

the same physical USB port every time you connect the module to the PC.

AP Binary or AP ASCII

9600

Use the serial port number identified above

MI.17.C1.02 - VLT

is a registered Danfoss trademark

MCD USB Module Instructions