Danfoss VLT MCD 200 설치 지침 - 페이지 4

{카테고리_이름} Danfoss VLT MCD 200에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss VLT MCD 200 5 페이지. Usb module
Danfoss VLT MCD 200에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (17 페이지), 설치 지침 매뉴얼 (6 페이지)

페이지 인쇄
Danfoss VLT MCD 200 설치 지침
Configuration
6. Identify the USB Serial Port assignment by checking Control panel > System > Hardware >
Device Manager> Ports (COM & LPT).
N.B.!:
If the USB port is not shown, disconnect then reconnect the cable. If the problem
persists, restart your PC.
7. Open WinMaster and change the Network Settings to:
Protocol:
Baud rate:
Serial Port:
8. Apply control voltage to the soft starter. Bring WinMaster on-line, then Search for Network
Starters.
N.B.!:
The starter may trip on Starter Comms while the Master is off-line. Reset the soft starter
and place the Master on-line.
N.B.!:
The drivers will configure the USB port that the module is connected to. You must use
the same physical USB port every time you connect the module to the PC.
AP Binary or AP ASCII
9600
Use the serial port number identified above
MI.17.C1.02 - VLT
®
is a registered Danfoss trademark
MCD USB Module Instructions
4