Danfoss DEVIreg Multi Panduan Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Termostat Danfoss DEVIreg Multi. Danfoss DEVIreg Multi 16 halaman. Self-limiting cables on drum
Juga untuk Danfoss DEVIreg Multi: Panduan Instalasi (12 halaman)

Halaman Cetak

The product complies with the EN/IEC Standard "Automatic

electrical controls for household and similar use":

• EN/IEC 60730-1 (general)

• EN/IEC 60730-2-9 (thermostat)

1�1

Safety instructions

Make sure the mains supply to the thermostat is turned off

before installation.

Important: When the thermostat is used to control a floor

heating element in connection with a wooden floor or

similar material, always use a floor sensor and never set the

maximum floor temperature to more than 35°C.

Please also note the following:

• The installation of the thermostat must be done by an

authorized and qualified installer according to local

regulations.

• The thermostat must be connected to a power supply

via an all-pole disconnection switch.

• The sensor is to be considered as live voltage. Have

this in mind if the sensor must be extended.

• Always connect the thermostat to continuous power

supply.

• Do not expose the thermostat to moisture, water, dust,

and excessive heat.

DEVIreg™ 530M

Installation Guide