DURKOPP ADLER H867 Petunjuk Tambahan - Halaman 8
Jelajahi secara online atau unduh pdf Petunjuk Tambahan untuk Mesin Jahit DURKOPP ADLER H867. DURKOPP ADLER H867 12 halaman. Tilting support
Halaman Cetak
3
Fig. 4: Installation I
(1) - Adjusting screws
(2) - Bolt
Handling step
1. Loosen the adjusting screws (1).
2. Pull out the bolt (2) on the lever (3).
Fig. 5: Installation II
(4) - Screws
(5) - Holder
Handling step
1. Set the machine to the working position.
2. Screw the holder (5) into the table top using the screws (4).
3. Screw the holder (6) into the base plate using the screws (7).
6
Installing the parts set
WARNING
Risk of crushing due to the weight of the machine!
Secure the machine against tipping during installation.
Installation of the tilting support by qualified techni-
cians ONLY!
Switch off the machine prior to installation.
①
④
⑤
Installing the parts set
③
②
(3) - Lever
(6) - Holder
(7) - Screws
Additional Instructions H867 - 00.0 - 03/2015
⑥
⑦
⑥