dymax T11146 Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengontrol dymax T11146. dymax T11146 16 halaman. Valve controller

System Interconnect

Refer to Table 1 to determine how to plumb the particular dispensing valve you are

using with the digital controller. For Model 300, 455, 475, 775, and 826 dispensing

valves, one of the Air-Out Ports must be plugged since these dispensing valves are

single acting.

Begin set-up by attaching a 0.25" [0.64 cm] Air Line to the Air-In Fitting on the rear of

the Controller.

Next, ensure that the Power Toggle Switch is in the OFF position. Plug the cylindrical

end of the DC Wall Mount Adapter into the Power Supply Receptacle on the back of the

Controller and plug the DC Wall Adapter in an appropriate outlet.

Plug the Foot Switch into the External Trigger Receptacle on the back of the Controller.

Attach the Material Reservoir to the Dispensing Valve and the appropriate air supply

Consult Dymax if you are unsure of this step.

pressure to the Material Reservoir.

Excessive air pressure to a Reservoir can result in a dangerous or deadly situation!

The system is ready for operation.

U S E R G U I D E

D V C - 3 4 5 V A L V E C O N T R O L L E R