DYNACO SCA-80Q Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Penguat DYNACO SCA-80Q. DYNACO SCA-80Q 12 halaman. C9 replacement
Juga untuk DYNACO SCA-80Q: Panduan Perakitan (15 halaman)

Halaman Cetak
DYNACO SCA-80Q Manual

Installing the New C9 into the Amplifier

1. Install the clamp, capacitor, harness assembly into the amplifier. Use the keps
nuts with the built in lockwashers (the 3 old nuts and lockwashers aren't used).
2. Orient the new assembly as shown in Figure 5.

Figure 5-Note the orientation of the capacitor assembly when installed into the amplifier

3. Reconnect the three positive wires as shown in Figure 6:
a. Wire 1 - the red wire from PC-19 terminal 2 to the positive harness
terminal where the two red-wires come together.
b. Wire 2 – the red wire from the right amplifier channel to one end of the
positive harness

Figure 6-Reconnecting the wires to the new C9

Page 7 of 12