DynaQuip WaterCop LEAK STOP+ Panduan Pemilik dan Panduan Instalasi - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pemilik dan Panduan Instalasi untuk Unit Kontrol DynaQuip WaterCop LEAK STOP+. DynaQuip WaterCop LEAK STOP+ 13 halaman.
Halaman Cetak
•
The valve closes with great force. It could cut off a fi nger. Keep fi ngers
and other items out of the valve when testing.
•
The WaterCop® Leak Stop
valve must NOT be installed where it could ignite fl ammable vapors or
explosive mixtures.
IMPORTANT:
•
Adherence to all local and municipal building, plumbing, and electrical
codes as they pertain to the installation of the WaterCop® Leak Stop
system is of utmost importance. Codes in some areas may require that a
licensed plumber be employed to do the installation, or that the proper
permits be obtained prior to any installation. Even if local codes do not
require a licensed plumber to do the installation, it is necessary that the
installer has a professional level of competence in both plumbing and
electrical skills to perform the installation. These instructions assume this
level of knowledge and skill. If in doubt, use a licensed professional.
•
Check with original appliance manufacturer for instructions regarding the
special servicing of water heater (or other water bearing appliance) when
inlet water supply is stopped for any reason or length of time.
CAUTION:
It is strongly recommended that eye protection be worn while servicing the
system. Failure to do so could result in personal injury.
NOTICE:
WaterCop® Leak Stop
valves and pressure reducers. Install 18" downstream from existing indoor
water meters to allow for future meter maintenance.
WARNING:
To reduce risk of electrical shock, fi re, or damage to property or WaterCop®:
1. Use a common, 120 VAC outlet. Use of a surge protector is recommended.
2. Do not use extension cords
•
Use of extension cords can cause fi res or electric shock.
•
Install WaterCop® Leak Stop
•
Install an outlet near the Leak Stop
3. Before opening case, unplug power cord. When the case is open, it is
possible to contact electrifi ed components. Always unplug the power cord
before opening the unit.
+
case is NOT EXPLOSION PROOF. The shut-off
+
should be installed downstream of existing shut-off
+
within reach of an existing outlet.
+
. Comply with all local codes.
+
3