HIGHLY LIQUID UMR2 Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Konverter Media HIGHLY LIQUID UMR2. HIGHLY LIQUID UMR2 11 halaman.

Highly Liquid

UMR2 RevC / V1.0

3.2.3 PRGM and MODE Switch Wiring

A PRGM switch is used during the UMR2 setup procedure and during firmware updates. Wire any

momentary or latching switch (not included) as shown.

A MODE switch is used to select the UMR2 mode of operation. Wire any latching switch (not included)

as shown.

If desired, remote STBY and ACT LEDs can be attached to the UMR2 as shown below. Current limiting

resistors (typical value of 1kΩ is shown) must limit LED current to 10mA or less.

Page 6 / 11