HIGHLY LIQUID UMR2 Руководство пользователя - Страница 6
Просмотреть онлайн или скачать pdf Руководство пользователя для Медиаконвертер HIGHLY LIQUID UMR2. HIGHLY LIQUID UMR2 11 страниц.
Highly Liquid
UMR2 RevC / V1.0
3.2.3 PRGM and MODE Switch Wiring
A PRGM switch is used during the UMR2 setup procedure and during firmware updates. Wire any
momentary or latching switch (not included) as shown.
A MODE switch is used to select the UMR2 mode of operation. Wire any latching switch (not included)
as shown.
3.2.4 Remote LEDs (Optional)
If desired, remote STBY and ACT LEDs can be attached to the UMR2 as shown below. Current limiting
resistors (typical value of 1kΩ is shown) must limit LED current to 10mA or less.
© 2012 Sonarcana LLC
Page 6 / 11